If you need urgent consulting help click here

Virtual LAN Sample Application

Overview

The VLAN sample application for Zephyr will setup two virtual LAN networks. The application sample enables net-shell and allows users to view VLAN settings.

The source code for this sample application can be found at: samples/net/vlan.

Requirements

Networking with the host system

Building and Running

A good way to run this VLAN application is with QEMU as described in Networking with QEMU Ethernet. You can use zeth-vlan.conf configuration file when running net-setup.sh script in Linux like this:

./net-setup.sh -c zeth-vlan.conf

Note that VLAN is only supported for boards that have an ethernet port or that support USB networking.

Follow these steps to build the VLAN sample application:

west build -b <board to use> samples/net/vlan -- -DCONF_FILE=prj.conf

The default configuration file prj.conf creates two virtual LAN networks with these settings:

VLAN tag 100: IPv4 198.51.100.1 and IPv6 2001:db8:100::1
VLAN tag 200: IPv4 203.0.113.1 and IPv6 2001:db8:200::1

Setting up Linux Host

The samples/net/vlan/vlan-setup-linux.sh provides a script that can be executed on the Linux host. It creates two VLAN interfaces vlan.100 and vlan.200 on the Linux host and creates routes to Zephyr.

If everything is configured correctly, you will be able to successfully execute the following commands on the Linux host.

ping -c 1 2001:db8:100::1
ping -c 1 198.51.100.1
ping -c 1 2001:db8:200::1
ping -c 1 203.0.113.1

The network packets to 2001:db8:100::1 or 198.51.100.1 will have VLAN tag 100 set to them. The vlan tag 200 will be set to network packets to 2001:db8:200::1 or 203.0.113.1.